ㅤ

TECHNICAL OVERVIEW

KEY PRODUCT SPECIFICATIONS

BELT LENGTH

10 ft or 15 ft

INCLUDED PLATES

Two 3-inch diameter ferrous steel mounting plates

PLATE INSTALLATION

Strong peel-and-stick adhesive

BARRIER MOUNT

Rubber-encased rear magnet

BELT END

Magnetic front belt clip

COMPATIBILITY

Can connect to suitable ferrous surfaces and compatible system receivers

SOURCE PRODUCT GRAPHICS

VISUAL REFERENCE

Escalator / glass-guardrail application

Magnetic glass-mount connection detail

INSTALLATION / ASSEMBLY

SOURCE-BASED PROCEDURE

Condensed for on-page guidance. Use the supplied product information and installation requirements when determining placement.

Plan the Barrier Span

Determine where the housing and belt end need to land on the glass or smooth surface and confirm the substrate is appropriate for adhesive mounting.

Install the Steel Plates

Apply the two included 3-inch ferrous steel plates to the prepared surfaces using their strong peel-and-stick adhesive.

Place the Barrier Housing

Attach the rubber-encased rear magnet to one installed steel plate. The rubber enclosure helps protect the mounting surface.

Deploy & Connect

Extend the belt and attach the magnetic front belt clip to the opposing plate, suitable ferrous surface, or compatible system receiver.

No separate glass-mount installation PDF was included in the supplied source set. The setup sequence above is based on the supplied product-page mounting information.

>>>>>

SYSTEM COMPARISON

COMPARE ALL 10 CONFIGURATIONS

PRODUCT GRAPHIC	15 FT	10 FT	15 FT	10 FT	15 FT	10 FT	10 OR 15 FT	10 OR 15 FT	10 OR 15 FT	10 OR 15 FT
PRODUCT	7.5" Heavy Duty Magnetic Base - 15 Feet	7.5" Heavy Duty Magnetic Base - 10 Feet	5.5" Magnetic Base - 15 Feet	5.5" Magnetic Base - 10 Feet	14" Sloped Base - 15 Feet	14" Sloped Base - 10 Feet	14.5" Slim Base	Wall-Mounted Retractable Belt Barrier	Magnetic Wall-Mounted Retractable Belt	Glass/Surface Mount Retractable Belt CURRENT PRODUCT
MOUNT / BASE	7.5" heavy-duty magnetic floor base	7.5" heavy-duty magnetic floor base	5.5" compact magnetic floor base	5.5" compact magnetic floor base	14" portable sloped weighted base	14" portable sloped weighted base	14.5" portable slim weighted base	Mechanical wall grip connector	Magnetic vertical-surface mount	Adhesive steel plates on glass / smooth surface
BELT REACH	15 ft	10 ft	15 ft	10 ft	15 ft	10 ft	10 or 15 ft	10 or 15 ft	10 or 15 ft	10 or 15 ft
BEST WHEN	Long, fixed-geometry queues need maximum magnetic hold	Tighter fixed-geometry queues need maximum magnetic hold	Floor footprint must stay minimal across longer spans	Floor footprint must stay minimal in dense layouts	Portable layouts need wider spans	Portable layouts need tighter turns and spacing	Portable post with slimmer base profile is preferred	Closure repeats in the same location	Closure must move between steel surfaces	Barrier is needed on glass or smooth surfaces
PRIMARY BENEFIT	18 magnets + 28.7 lbf tip-over force; removable post	Heavy magnetic hold + controlled 10-ft geometry	Smallest floor footprint with 15-ft reach	Smallest floor footprint for dense queues	No floor installation; fewer posts over wider spans	Maximum portability for compact layouts	Portable stability with 10/15-ft flexibility	Zero floor footprint; opposing receiver included	Tool-free relocation; no permanent fasteners	Creates magnetic barrier points on glass/smooth surfaces